Super Seal India Ltd. Super Seal India Ltd. Super Seals India Limited
Super Seals India Limited Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seal

Super Seal
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited
Super Seals India Limited


Super Seals India Limited

Super Seal India Ltd.
Super Seals India Limited

Oil Seal Data Sheet


1. Seal application
2. Bearing-Non-frictional/Bi-metal/Plain
i) If plain, please state tolerance for running clearance
ii) Will end float be present? If so, state amount
3. Fluids to be sealed
i) Type
ii) Grade
iii) Make
iv) Viscosity
v) Pressure    Kg/Cm/PSi    i) Inside    ii) Outside 
vi) Fluid level from the centre line of shaft   (mm)
vii) TemperatureContinuous                                           Intermittent
  Max  Min    Max  Min 
viii) Is it circulated or localised or subject to churing?
4. Does the seal have to protect bearings
against abrasives, water, mud etc?  If so, give full details
5. If a vaccum is present, please state  inches of mercury.
6. Is the seal to pass over a keyed or spline shaft? (give detailed drawing)
7. SHAFT
i)  Diameter Max   Min  
ii) Material
iii) Hardness
iv) Surface roughness
v)  Dynamic runout    TIR Max.
vi) Axis of Rotation    Vertical/Horizontal
8. HOUSING
i)  Bore diameter Max   Min  
ii) Depth
iii) Material
iv) Hardness
v)  Surface roughness
vi) Misalignment to shaft     TIR Max.
9. Dynamic conditions      Shaft/Housing
i)  Rotary (RH/LH)        RPM  
ii) Reciprocating   Length of stroke
iii) Oscillating   Degrees
 Cycle/Min
iv) Hardness
v)  Surface roughness
vi) Misalignment to shaft   TIR Max.
10. Assembly condition and problems (possibility) Please give details  
11. Please enclose detail drawing of proposed application  
Drawing/part No  
12. Performance Test
i) Test schedule Test cycles
ii) Test temperature Allowable leakage
*as viewd from the outside face of the seal
Date
*Email
*Name
*Designation
Customer
Address
Part No
*Enter the code shown on image:






OUR PRODUCTS RANGE